28/02/2026 10:35 pm
Topic starter
Notifications
Clear all
Motorola
5
Posts
6
Users
0
Reactions
135
Views
0
Just got my hands on the Edge 60 Pro and man this thing is slick but the charging situation is tripping me up. I usually know my way around PD and PPS specs but Motorolas TurboPower stuff is always a bit finicky with third party bricks.
My logic was that my 100W Anker would handle it no problem but its barely hitting 30W according to my cable readout. I need something that actually hits those top speeds because Im traveling for a big conference next week and only have like 15 minute windows to top off. Should I just hunt down the official 125W brick or is there a GaN charger that actually speaks Motos language?
5 Answers
12
28/02/2026 11:10 pm
Just catching up on this thread and wow, I went through this exact same headache last month! Paying $80 for a brick felt like a total ripoff lol. My journey led me to test a bunch of budget gear from Amazon because I’m obsessed with finding value. Some of these GaN chargers are amazing and safe if you check the certifications. I love it when you find a cheap solution that actually works as well as the pricey stuff!!
- The Toocki 140W GaN USB C Charger became my go-to since it was a fraction of the cost of the official one and still hits high PPS ranges.
- Safety is a huge deal tho!! Always check for over-temperature protection because cheap bricks can literally melt if they're trash.
- Grab a 100W rated cable with an E-marker chip or the phone won't even try to draw the high power. Honestly, it’s been fantastic. It hits near-max speeds and doesn’t get too hot. Best budget hack for the Edge 60 Pro for sure!
11
28/02/2026 10:50 pm
Adding my two cents here, you gotta be careful with PPS ranges. Most bricks wont hit the high current Moto needs. I would suggest looking at the Ugreen Nexode 100W GaN Wall Charger if youre trying to save some cash. It might not hit the full 125W, but its a solid budget alternative. Just make sure to use a 5A cable tho or you'll be limited anyway...
4
28/02/2026 11:40 pm
^ This. Also, I’d actually go a different route for travel tbh. I’ve been super satisfied with the Baseus 140W GaN5 Pro Wall Charger and it basically replaced my official Moto brick. No complaints here.
- Way more compact for packing
- Handles PPS handshakes way better than older Anker stuff
- Cheaper than hunting down Moto OEM It works well and hits those high numbers pretty reliably in my experience.
3
03/03/2026 11:37 am
Finally someone says it. Ive been thinking this for a while but wasnt sure.
1
28/02/2026 10:36 pm
> its barely hitting 30W according to my cable readout Moto uses a proprietary PPS profile for 125W speeds. Ngl, just grab the official Motorola+TurboPower+125W+Wall+Charger&linkCode=osi&------123456890?5422-20" target="_blank" rel="nofollow sponsored">Motorola TurboPower 125W Wall Charger because most bricks don't have the specific handshake needed.
