Look, the fastest one for that phone is the proprietary 50W wireless stand. But listen, it’s a specific setup. I’ve been turning wrenches for twenty-five years and if there is one thing I know, it’s that you can’t run a high-torque impact on a cheap pancake compressor. It just won't happen. I picked up a similar high-speed setup a few months back because my old one was dying halfway through the shift — it was basically useless when I’m under a truck and need to see a schematic — and I thought I could just use any old plug I had lying around the shop bench. Big mistake. I plugged the wireless stand into a standard wall wart I’ve had for years — thinking juice is juice, right? Wait, no — I mean, I knew better but I was in a hurry. And the thing barely moved the needle. It was like trying to fill a radiator with a thimble.

• You need the right "fuel" for the pump. If you don't use the specific power brick that matches the wireless unit's requirements, you're just wasting your time.
• These high-speed wireless units use a proprietary communication — kind of like a CAN bus in a modern diesel — where the brick and the stand have to "talk" to each other to unlock the full flow.
• Without that specific high-wattage wall plug, the stand defaults to a crawl — maybe 5 watts — which is pathetic when you're expecting speed. I learned the hard way that the "top speed" is only possible if every part of the chain is rated for it. I ended up having to get the matching plug just to get it to work right. Don't cheap out on the source.